Good morning everyone,
I am having an issue connecting to the ECU of my MK2B Punto 1,8 16V with MES. It did work in the past but I have not tried to connect in a while.
I am using the VAGCOM KKL cable with the red adaptor. I was orginally using MES V4,5 but upgraded thinking this could help. It did not help, the only other thing I can think of is that recently I installed .NETFramework 3,5 on my PC. I am using Win 10.
Below are some screengrabs of my settings and what happens when I try to connect and the results of a scan etc.
1 post • Page 1 of 1