Punto 199 / BJ.2012 Blue&Me removal

General messages
Post Reply
idlop
Posts: 9
Joined: 09 Feb 2018, 15:26
Location: Offenbach - Hessen

Punto 199 / BJ.2012 Blue&Me removal

Post by idlop » 16 Sep 2019, 12:38

Hello guys,

Punto Evo 1,4 8V ...the Blue and Me is dead and now we want to remove it from proxy, normal alugment fail ...does anyone now which bites we have to change to get a successful aligment ?

Tony
Posts: 2
Joined: 26 Apr 2020, 08:41

Re: Punto 199 / BJ.2012 Blue&Me removal

Post by Tony » 26 Apr 2020, 08:53

I've managed to remove the Blue&Me module and stop the blinking odometer on a 2012 Alfa Giulietta.

I think the most important thing is to disconnect the battery before removing the Blue&Me module from the CAN bus network. I reckon this applies to all modules which are removed from the CAN network, like headunits/radio's etc.
I removed the Blue&Me unit without disconnecting the battery at first. It resulted in a permanent fault code in the body computer which (among others) leads to a blinking odometer. The fault code couldn't be cleared. Then I reconnected the blue and me module and cleared the fault codes. Finally I disconnected the battery and the blue and me module. After reconnecting the battery I could clear all fault codes in the body computer and the blinking of the odometer stopped.

Please see my video on youtube: https://www.youtube.com/watch?v=RD__7upfeaw

giobbi80
Posts: 5
Joined: 19 Jul 2019, 09:34

Re: Punto 199 / BJ.2012 Blue&Me removal

Post by giobbi80 » 22 Jul 2021, 22:44

Tony wrote:
26 Apr 2020, 08:53
I've managed to remove the Blue&Me module and stop the blinking odometer on a 2012 Alfa Giulietta.

I think the most important thing is to disconnect the battery before removing the Blue&Me module from the CAN bus network. I reckon this applies to all modules which are removed from the CAN network, like headunits/radio's etc.
I removed the Blue&Me unit without disconnecting the battery at first. It resulted in a permanent fault code in the body computer which (among others) leads to a blinking odometer. The fault code couldn't be cleared. Then I reconnected the blue and me module and cleared the fault codes. Finally I disconnected the battery and the blue and me module. After reconnecting the battery I could clear all fault codes in the body computer and the blinking of the odometer stopped.

Please see my video on youtube: https://www.youtube.com/watch?v=RD__7upfeaw
Hello, if removed without disconnect the battery, when re connect the B&m the fault code where are for erase?
Then disconect the battery remove the b&m and applythe proxy allignament and erase the faultcode?

Post Reply