MES 4.3 not working for me

General messages
Post Reply
bowdenandymecom
Posts: 12
Joined: 20 May 2017, 20:34

MES 4.3 not working for me

Post by bowdenandymecom » 03 Dec 2018, 17:21

I've upgraded to MES 4.3 and can't get it to work. 4.2 worked perfectly OK for me.

My configuration is MES Multiplex connected by USB to a Mac Book Pro running Parallels Desktop 14.1 and Windows 7.

The interface test function of MES times out though the MES unit is visible to Windows as a drive.

I have upgraded Parallels Desktop from 14.0 since I last used MES 4.2, but I very much doubt if that could be the cause of my problem.

I've no desire to start using the Multiplex WiFi or Bluetooth modes. I'm wondering whether I need to update the Multiplex units firmware to get 4.3 to work even though I'm using USB.

Has anyone had success using MES 4.3 with Multiplex or otherwise yet?

Thanks

Andy

s130
Posts: 554
Joined: 20 Jan 2010, 10:07
Location: Southampton, United Kigndom
Contact:

Re: MES 4.3 not working for me

Post by s130 » 04 Dec 2018, 11:28

If you can I would try using BOOTCAMP on your MAC to run windows natively as opposed to under emulation/virtual machine. Do this before looking to update any other software/drivers/firmware.
Fiat Strada/Ritmo Abarth 130TC, Barchetta 2005 , 500X Cross Plus

bowdenandymecom
Posts: 12
Joined: 20 May 2017, 20:34

Re: MES 4.3 not working for me

Post by bowdenandymecom » 05 Dec 2018, 14:22

Thanks for the BOOTCAMP suggestion. I'm reluctant to start using Bootcamp as I use Parallels for a number of other things.

Until this week MES Multiplex has worked fine for me with Parallels Desktop.

I am now finding that the Multiplex unit no longer shows as a mapped drive whether I'm using Parallels Desktop or just Finder and I've tried it with another Mac getting the same symptoms.

The green LED is flashing rapidly. I'm wondering if I've got a hardware fault in the CANtieCAR unit.

Also I tried reverting to MES 4.2 without success.

Andy

Post Reply