Pleše help barchetta 1997 ecu scan

General messages
Post Reply
barchetta 1997
Posts: 3
Joined: 23 Feb 2018, 19:59

Pleše help barchetta 1997 ecu scan

Post by barchetta 1997 » 24 Feb 2018, 11:22

Hello I'm new by.Have problem to conect barchetta 3 pin +VAG Kkl 409.1 in adapter is ftdi chip
I have win 7ultimate+ sp1 64bt
Dovnload ft23r usb u art driver installed in control panel is ok show port5.
My 3pin adapter hawe only red+ wire no black -
Barchetta hawe two pin port white wire and black wire.
Can anyone help mee please

barchetta 1997
Posts: 3
Joined: 23 Feb 2018, 19:59

Re: Pleše help barchetta 1997 ecu scan

Post by barchetta 1997 » 24 Feb 2018, 14:03

I found the 4 pin on kkl is not conect no were in kkl board,but 5 pin go no were in board

barchetta 1997
Posts: 3
Joined: 23 Feb 2018, 19:59

Re: Pleše help barchetta 1997 ecu scan

Post by barchetta 1997 » 24 Feb 2018, 19:12

when i conect multi cu scan with elm327 is port and trans. ok and say conect vag kkl,when i conect vag kkl say TESTING LATENCI WITH200BITES OF DATA....THE OPERATION IS TIMED OUT.
PLEASE HELP

speedy100
Posts: 10
Joined: 12 Sep 2017, 19:31

Re: Pleše help barchetta 1997 ecu scan

Post by speedy100 » 25 Feb 2018, 11:33

barchetta 1997 wrote:when i conect multi cu scan with elm327 is port and trans. ok and say conect vag kkl,when i conect vag kkl say TESTING LATENCI WITH200BITES OF DATA....THE OPERATION IS TIMED OUT.
PLEASE HELP
Go to Your COM: port settings in WIN Control Panel-System-... and change the settings there for the Latenci. You might need to try different settings before it is OK.

Good luck !
If You think that knowledge is expensive then try ignorance...

Post Reply