Multiecuscan 2.0 - WORK IN PROGRESS!!!

General messages
EnIgMa
Posts: 301
Joined: 23 Mar 2010, 21:52
Location: Italy

Re: Multiecuscan 2.0 - WORK IN PROGRESS!!!

Post by EnIgMa » 31 Mar 2010, 21:35

yani wrote:Please be patient! I'm working very hard to release v2.0.

As far as I know Fiat Grande Punto (2007) is CAN-only. You cannot do anything with VagCom cable. You'll need ELM 327.
However, it will not be supported in v2.0. I'll add support for Grande Punto soon.

Yani
Great! Great!

Just, i didn't understand if we will have to modify the cable of elm-device as we do for the vagcom cable or not.

thank you! :)

sixpotman
Posts: 24
Joined: 13 Feb 2010, 13:30

Re: Multiecuscan 2.0 - WORK IN PROGRESS!!!

Post by sixpotman » 31 Mar 2010, 22:43

More than likely if the pins are not connected
I have a Gendan Elm and it will need altering
to work.

John

s130
Posts: 691
Joined: 20 Jan 2010, 10:07
Location: Southampton, United Kigndom
Contact:

Re: Multiecuscan 2.0 - WORK IN PROGRESS!!!

Post by s130 » 01 Apr 2010, 17:38

Gendan Elm Interface


Care to clarify? Why would this interface require modification?

sixpotman
Posts: 24
Joined: 13 Feb 2010, 13:30

Re: Multiecuscan 2.0 - WORK IN PROGRESS!!!

Post by sixpotman » 02 Apr 2010, 18:08

Gendan Interface needs altering as not all the required
pins in the diagnostic socket are connected for diagnostics.
Same as the VAG.

John

brutale
Posts: 3
Joined: 03 Apr 2010, 07:03

Re: Multiecuscan 2.0 - WORK IN PROGRESS!!!

Post by brutale » 03 Apr 2010, 07:07

Hi
need translate to Chinese?
I can help

Regards

kayman
Posts: 1
Joined: 20 Jan 2010, 07:07

Re: Multiecuscan 2.0 - WORK IN PROGRESS!!!

Post by kayman » 12 Apr 2010, 12:42

Tried to connect via ELM 1.5a, but it didn't work. So I have ordered an ELM 1.3 and hope, that it will work to reset the Service message at my Stilo 1.6...

Kay

Flo13
Posts: 5
Joined: 12 Apr 2010, 16:10

Re: Multiecuscan 2.0 - support ABS Teves Mk20

Post by Flo13 » 14 Apr 2010, 00:22

mike1327 wrote:Hi Yani! Will version 2.0 support ABS Teves Mk20 for Fiat bravo 1.9JTD, 1999
Your vehicule was made after 1998 so it's not anymore a TEVES MK 20 ABS, but a BOSCH 5.3 ABS.

I give you a tip to easily reconise your abs type :

- TEVES MK 20 : On the front wheels, the sensor rings are positioned on the transmission drive shaft
Image


- BOSCH ABS 5.3 : On the front wheels, the sensor rings are in the bearing seal
Image

Image

Post Reply