Always disconnecting from ABS

General messages
Post Reply
gtr-tobi
Posts: 1
Joined: 18 Jan 2011, 19:06

Always disconnecting from ABS

Post by gtr-tobi » 18 Jan 2011, 19:13

I tried to connect to the Bosch ABS 5.3 ecu from a 1999 multipla.

Multiecuscan connects to ABS an then it is connected.

After 1-2 seconds the programm disconnects automatically from the ABS unit, an then i am on the start screen again.

Connecting to Engine ecu works without problems, and port and programm settings should be ok, too.

Whats the problem?

I am using the newest version of multiecuscan and a vag kkl interface connected to obd pin 1, this should be ok.

Post Reply