Fiat Doblo radio change vp1 to vp2

[Fiveo]

Hi,
I have a problem with radio retrofit in my ”16 Fiat Doblo. Factory it have radio Continental VP1, i bought used one 5’ Uconnect VP2 ECE DAB NAV RVC and aftermarket reverse camera. After install, almost everything in radio works exclude time/data change, in engineering menu almost everything is not light up, mileage blink, and reverse camera(i install it to correct pins) doesnt work. When i put reverse gear nothing happens.

I try to do Proxi alignment but unsuccesfull. There is a problem with telematic node


GPS/DAB antena ll be installed later

I think new radio is not recognized, what in MES i can change it for correct one/activate reverse camera and repair proxy alignment?
Big thx for help, a spend a lot of time read about it and nothing work

[Fiveo]

My doblo is ’16 model, radio unit is VP2Refresh with production date 28.07.2018 like on a picture. From 2018 everything works behind SGW- maybe some problem with that?

Thats my config for now
4B 10 00 05 10 00 00 00 4B 10 00 05 10 00 00 00 41 00 00 00 10 00 00 00 01 00 00 00 10 00
4B 10 00 05 10 00 00 00 09 00 00 04 10 00 00 00 4B 10 00 05 10 00 00 00 09 00 00 04 10 00
33 36 32 36 33 31 33 35 35 30 35 4F 55 54 50 55 54 44 4A 49 54 20 15 12 30
4B 10 00 05 10 00 00 00 09 00 00 04 10 00 00 00 85 40 73 07 7B 00 00 30 80
20 00 16 00 1E 00 00 06 0B 02 46 C0 0A 50 08 09 10 05 04 08 00 80 00 60 00
00 00 00 54 03 43 01 00 22 00 00 00 21 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 9D 00 94 00 01 00 00 82 12 37 20 00 00 00 B0 00 04 00 00
00 00 00 00 01

[abarthmultijet]

Very interested in the solution, I want to do the same to my Doblo.

[chrener]

Hi guys
Try to change byte 111 to 02
And sometimes it needs extend proxi lenght up to 235 or 250 bytes ( depend on radio SW version)
good luck!

[Fiveo]

Hi guys
Try to change byte 111 to 02
And sometimes it needs extend proxi lenght up to 235 or 250 bytes ( depend on radio SW version)
good luck!

Thank you! It work I change byte to 02, and extend Proxi to 250bytes. Proxi align success without errors, odo stop blinking!
Camera activated using alfaObd, but when i put rear gear-screen is change to blank, and info „camera system-not available”
Installed to wrong pins or what? Camera is aftermarket from Aliex