PROXI - Enabing Xenons Alfa Stelvio

multiecuscan program usage help
Post Reply
frankp2112
Posts: 5
Joined: 06 Dec 2022, 16:01

PROXI - Enabing Xenons Alfa Stelvio

Post by frankp2112 » 04 May 2023, 15:20

Hi,

I have been trying to enable Xenons on my Stelvio.

I have changed the setting in the MES and successfully run a proxi config.

However the DRL and indicators are not working - I have checked the light and it ok and the connector is fine.

I can only assume that the change is not taking affect after the proxi and the BCM is not connecting to the LEDS

Any suggestions on what I may have missed?

Thanks

Frank

shpuncik
Posts: 306
Joined: 19 Oct 2018, 16:43

Re: PROXI - Enabing Xenons Alfa Stelvio

Post by shpuncik » 04 May 2023, 17:53

wiring is different between halogen and xenon headlights

frankp2112
Posts: 5
Joined: 06 Dec 2022, 16:01

Re: PROXI - Enabing Xenons Alfa Stelvio

Post by frankp2112 » 04 May 2023, 18:00

Hi,

The wiring is the same
the xenon lights work fine.
The LED's do not when when I checked the voltage at the pin it drops when the LEDS are plugged in.

I suspect the BCM is not picking up the changes but this is me having a guess.

Thanks

Frank

chrener
Posts: 175
Joined: 07 Jun 2018, 13:08
Location: Košice, Slovakia
Contact:

Re: PROXI - Enabing Xenons Alfa Stelvio

Post by chrener » 06 May 2023, 06:26

Hi!
Wiring is not same!
You have to add 2 wires for both lamps to activate DRL and for correct function of turning lights...
Then you have to change proxi settings...
Good luck!
Jeep Renegade 1.4 MultiAir TURBO 75th Anniversary

frankp2112
Posts: 5
Joined: 06 Dec 2022, 16:01

Re: PROXI - Enabing Xenons Alfa Stelvio

Post by frankp2112 » 06 May 2023, 19:26

Hi,

Can you elaborate about the wires?
I have checked the power at the connectors and can see power there.
I have attached the picture of the connector

My understanding is these are the connectors
1– Low beam positive control . 8 – NA.
2 – DRL/side Marker Lamp Positive Control 9 – Vertical Adjustment Motor Positive Control
3 – DRL/side Marker Lamp Signal 10 – NA.
4 – Direction Indicator Lamp Positive Control 11 – NA.
5 – High Beam Positive Control 12 – Vertical Adjustment Motor Signal
6 – NA. 13 – Ground
7 – NA. 14 – Ground

Also what proxi change is there I can only see the xenon and the shutter ti chnage?

Thanks

Frank

Post Reply