Connection problem

multiecuscan program usage help
Post Reply
dCop
Posts: 2
Joined: 28 Sep 2021, 09:27

Connection problem

Post by dCop » 28 Sep 2021, 09:40

Hi to all!!!

I have problem with connection, Punto 1.3jtd 2014 and Bravo 1.6jtd 2008. Using OBD Direckt multiprotocol usb interface (ELM 327 1.3/1.4/1.4b/2.1), from Fuchs electonics. All test are ok but when trying to connect to engine module its "Can bus error", to body module with yellow (when testing its not compatible with this interface, but it was last year?!) adapter its "Can bus error". Any ideas?

s130
Posts: 941
Joined: 20 Jan 2010, 10:07
Location: Wrexham, North Wales

Re: Connection problem

Post by s130 » 29 Sep 2021, 06:42

You say was working last year. Was that on a previous release of MES? If so install the earlier/previous release and see if that solves your problem. If it does then inform MES Support.
Fiat Strada/Ritmo Abarth 130TC, Barchetta 2005 , 500X Cross Plus

dCop
Posts: 2
Joined: 28 Sep 2021, 09:27

Re: Connection problem

Post by dCop » 29 Sep 2021, 08:11

Yes, on a previous version. Few days ago I have downloaded new and bought license. I will give it a try, thanks.

s130
Posts: 941
Joined: 20 Jan 2010, 10:07
Location: Wrexham, North Wales

Re: Connection problem

Post by s130 » 29 Sep 2021, 11:53

When you do testing then there is a Send Report button/text at the bottom of the main panel. You can create a report for a good version run and bad version run. That will help diagnosis.
Fiat Strada/Ritmo Abarth 130TC, Barchetta 2005 , 500X Cross Plus

Post Reply