Elm327 problem with 500x

multiecuscan program usage help
Post Reply
ecufire
Posts: 1
Joined: 07 Jul 2020, 09:56

Elm327 problem with 500x

Post by ecufire » 07 Jul 2020, 10:09

hello everyone I have to do proxy alignment on the can line to a fiat 500x but the MES 4.6r1 shows this error: interface too slow.try to configure elm327 (high speed). I tried to change the speed and check the high latency mode box on interface impistazioni but it still doesn't work. engine diagnosis and all other modules are working properly

Post Reply