Failed to Proxi Alignement - Help

multiecuscan program usage help
Post Reply
Prezzemolino
Posts: 2
Joined: 14 Jun 2018, 13:27

Failed to Proxi Alignement - Help

Post by Prezzemolino » 14 Jun 2018, 13:37

Hi there,

today i tried using multiecuscan 4.0 to perform proxi alignment on jeep renegade 2.0 multijet.

something gone wrong and i know why, in the mid of alignement ecuscan asked me to change cable interface adaptors, i didn't change it and now, when i try to connect on the body 4 modules are gone (EOL Error).

if i get back this 2 adaptors (A5 and A6) and i will perform again proxi alignement, it would be Ok? i've lost something for my mistake? i have to do anything else?

Thanks for the support,

M.

Post Reply