FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Hi Whiley I have a similar ELM327 cable. Which is exactly the resistor to remove? (I see no photo attached in your latest post). Thank you!
-
- Posts: 1
- Joined: 28 Apr 2024, 16:24
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Hi Whiley, I have the same circuit board but I'm unsure what to do. There doesn't seem to be a photo attached. Please could you give a bit more advice? Cheers.Whiley wrote: ↑24 Apr 2024, 19:19Sorted buzzed the board and found the 120 ohm resistor connected to 6 and 14, see picture attached, all works now and managed to do dpf reset and connect fully to ecu. I bought this kit off of amazon and for anyone who has this problem and has the red board see picture below of 120 ohm resistor to remove.
-
- Posts: 1
- Joined: 02 May 2024, 21:36
Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
For my ELM327 USB interface, the 120ohm resistor is located here:
https://ibb.co/0tth1wp
Encircled in blue. Usually between pins 6 and 7 of the CAN transceiver integrated circuit (8 pin SOIC, here named 1044)
https://ibb.co/0tth1wp
Encircled in blue. Usually between pins 6 and 7 of the CAN transceiver integrated circuit (8 pin SOIC, here named 1044)