Page 1 of 1

Support for original ELS27 v4 interface

Posted: 08 Apr 2019, 21:33
by AlfaRed69
Hi yani,
Is it possible in the future to have support for the original ELS27 v4 interface?
At the hardware level it supports the KKL function and is wired on pins 1 & 9 yellow connector is pin 3 & 11 blue connector.
From the manufacturer's website I learn that this is an alternative function - this is a protocol that can be enabled on this contact when the relay is activated in the adapter. The relay is activated by a specific command and for this there must be support from the software side.
Link info:
Sorry for my English!
Thank you