Multiecuscan

Hi yani,
Is it possible in the future to have support for the original ELS27 v4 interface?
At the hardware level it supports the KKL function and is wired on pins 1 & 9 yellow connector is pin 3 & 11 blue connector.
From the manufacturer's website I learn that this is an alternative function - this is a protocol that can be enabled on this contact when the relay is activated in the adapter. The relay is activated by a specific command and for this there must be support from the software side.
Link info: https://els27.ru/index.php?route=information/information&information_id=7
Sorry for my English!
Thank you

Commands for configure ELS27

KKL mode:
STGPC28:O Configure general purpose pins
STGPOW28:1 Write output latches

No use interface KKL line!!!!!!!!!

ELS27 device is in raw KKL mode.
To return to normal mode you have to unplug both OBD (16-pin DLC) and USB ends of the cable and connect it again after that.



MM_CAN switch relay pin 6&14 to pin 1&8/9:

STGPC35:O Configure general purpose pins
STGPOW35:1 Write output latches
ELS27 device is in MM_CAN mode.
No use YELLOW adapter 3!!!!!!!!!!!!



MS_CAN pin 6&14 to 3&11:
STGPC35:O Configure general purpose pins
STGPOW35:0 Write output latches
ELS27 device is in MS_CAN mode.
No use BLUE adapter 5!!!!!!!!!!!!!


Thanks