Hello dear developer,
As MES is the only program that successfully connects to the 3-pin, giving me the ability to diagnose my own vehicle, I was wondering if the following could be done:
According to service manual there should be values available in the diagnostics for the knock sensors in the Fiat Marea 2.0 20v using the Bosch 2.10.4 ECU, I am hoping that they could be added to the program if possible.
Checking the other cars sharing this ECU it showed those do not have this either.
(Using MES 4.5 registered on my Marea, FREE in Simulation mode to check other vehicles)
Post multiecuscan feature requests
1 post • Page 1 of 1