ISO Codes

Report any bugs found in multiecuscan
Post Reply
devc
Posts: 31
Joined: 13 Feb 2010, 20:34
Location: South Africa
Contact:

ISO Codes

Post by devc » 11 Mar 2010, 09:19

Hi Yani,
I notice in Fiat Examiner there is a option: "Ignore ISO Codes"
I think, if one can ignore the ISO codes, one can access more control units with the same communications procedures.
It may be worthwhile to look into that for your new version.
Thanks, you have been doing a fantastic job so far!
Regards,
Dev

yani
Site Admin
Posts: 1175
Joined: 06 Nov 2009, 16:40

Re: ISO Codes

Post by yani » 11 Mar 2010, 11:22

You CAN ignore ISO codes. Just press Y when the program shows the mesage "Invalid ISO Code! Press Y To Continue or Press N To Abort".

Yani

devc
Posts: 31
Joined: 13 Feb 2010, 20:34
Location: South Africa
Contact:

Re: ISO Codes

Post by devc » 11 Mar 2010, 21:48

Oops, have not seen that yet. Sorry!
Regards, Dev

ARomeo
Posts: 86
Joined: 06 Jan 2010, 10:45

Re: ISO Codes

Post by ARomeo » 14 Mar 2010, 13:17

yani wrote:You CAN ignore ISO codes. Just press Y when the program shows the mesage "Invalid ISO Code! Press Y To Continue or Press N To Abort".

Yani
I pressed Y, but I coucn't see values of parameters

Post Reply