barchetta '99

Report any bugs found in multiecuscan
Post Reply
Salvo!
Posts: 3
Joined: 14 Feb 2015, 13:08

barchetta '99

Post by Salvo! » 17 Apr 2015, 18:35

Hello to everyone! I'm Salvo. I've read many treads of connection between barchetta and multiecuscan, but maybe you can help me..I have a fiat barchetta 99 and I have bought the 3pin to OBD and a KL cable to Usb (it has the switch to pass from pin 7 to 1/9) I have downloaded the drivers for that cable and i have downloaded the last version of multiecuscan (v.2.4)
but I cannot connect.. when I try to scan ecu the message that appare is: "scanning...COMPLETE" without any value.
Can you help me? thanks in advance

Alfaeddy
Posts: 1350
Joined: 19 Feb 2011, 17:43
Location: Germany , Aarbergen

Re: barchetta '99

Post by Alfaeddy » 18 Apr 2015, 08:15

Hello Salvo

You've installed the driver!

The KKL must always be set to switch position 7 with 3pin adapter
Each controller has its own 3pin connector


Close your interface to the PC and give the extra wires red and black to 12 volts.
Then press on MES / Settings / Interfaces / test and make a screenshot on here once .


Greeting Eddy

Salvo!
Posts: 3
Joined: 14 Feb 2015, 13:08

Re: barchetta '99

Post by Salvo! » 30 Apr 2015, 20:35

thank you for your reply, here the screenshot...
Attachments
mes.jpg
mes.jpg (243.33 KiB) Viewed 4838 times

Alfaeddy
Posts: 1350
Joined: 19 Feb 2011, 17:43
Location: Germany , Aarbergen

Re: barchetta '99

Post by Alfaeddy » 01 May 2015, 08:37

Hello Salvo

the Latency
min. + max. is too high

Open on the laptop the
Control Panel / Device Manager / Comport / Preferences / Advanced
and change there the Latency Time to 1 (previously 16)

Then try again to test

The Latency min. + max. should be below 10 ms.

Greeting Eddy

Salvo!
Posts: 3
Joined: 14 Feb 2015, 13:08

Re: barchetta '99

Post by Salvo! » 04 May 2015, 20:40

Hello Eddy!
In this way finally I'am connected to the ecu! :D
thank you very much!

Marcilio
Posts: 1
Joined: 16 May 2015, 16:16

Re: barchetta '99

Post by Marcilio » 18 May 2015, 18:26

I'm Problems No Multi ecu My , IT simply does not open anything.

MichalM
Posts: 4
Joined: 14 Apr 2017, 18:15

Re: barchetta '99

Post by MichalM » 14 Apr 2017, 18:54

Hi guys,

Sorry to refresh this thread but I am in need of your expertise. I have been trying to connect to the ECU of my 95' Barchetta. The connector I have found in the engine compartment looks like this:

Image

It has 4 not 3 pins, but the 3 pins are only wired so I suppose it might be it.

Did your connector was in the same place? Was it 3 pins?

Michal

Post Reply