Multiecuscan

What happens if you change Byte 65 to the value 60 using the restyling BCM? If I set it to 60, it's always the same as it was at 20 or 30. These trials, however, have always made them on the bench, not on the car. Have a look at http://500crew.com/forum/viewtopic.php?f=23&t=1354 where the OP has do...

The most obvious difference I can see is Byte 65 has a value of 20 and we know that particular byte changes the graphics. I'll change that value on my custom proxy and see what happens. This is not the secret of new graphics. I have the bodycomputer of a 500 Abarth restyling experimental that still...

vabene4C wrote:Amazingly I got everything to work 1st time on the Multiscanecu install. I did'nt see anything in Proxy that seemed to allow me access at this time. Will check a couple other ideas tomorrow.

You have to make the proxy change from yani.

The most obvious difference I can see is Byte 65 has a value of 20 and we know that particular byte changes the graphics. I'll change that value on my custom proxy and see what happens. This is not the secret of new graphics. I have the bodycomputer of a 500 Abarth restyling experimental that still...

Hello Following a switch from uconnect 5 '' to a uconnect 6.5 '' live I encountered this problem Finished the physical installation of uconnet live 6.5 i had flashing kms fixed with the alignment I connected my elm327 and I did the proxy alignment and it happened a strange thing .. The first is tha...

I have a US Spec 2015 Alfa 4C Launch Edition. I have installed European tail lights, Euro have orange turn indicator, US has red. They are easily swapped, but the US model operates differently than the Euro version. On the US version the brake light also operates the red turn signal and when signal...

Hi Alex, Can you post or PM a screenshot of your Custom Proxy data for the TFT graphics in your picture below please? Grazie :D Of course! I send you the 500 Abarth proxy code in which your tft was mounted! Fiat 500 Abarth Restyling: 33 32 31 35 30 30 31 39 31 39 30 4F 55 54 50 55 54 44 4A 49 54 20...

Hi, why is not possible to activate that function on body computer ? is possible to insert it? Do not know, can it be activated via multiecuscan? Or did you try to install handle and electric lock and see if it works? It may be that the body computer does not own the internal hardware, because they...

I've been trying to program my Panda remote locking key. I've been through the procedure for my model several times and, while the key works in the ignition and starts the car, I can't get it to remotely lock/unlock. Any ideas? P.S I know my equipment works as I can connect to the car and use actua...

Hi, is there option in Multiecuscan to enable automatic direction light three-times-repeat after short usage aka comfort direction lights for Croma? I know it is enabled in post-lift version of this car. I do not think it can be enabled through testers. It could be a Croma Restyling software implem...