Multiecuscan

Hi, I released version 1.4 today. These are the major improvements: - Added Marelli SELESPEED CFC208F support - Added Marelli SELESPEED CFC209F support - Added Lucas EBC 430 ABS support - Added TRW Electric Power Steering support (you need to connect your cable to pin 9 for this ECU) - Improved comm...

Hi,
I don't support any of the modules installed in your car.
The next release will support the TRW power steering module which is used in Croma '05.
I will also support the EDC16/CF4 diesel management.

Hi,
I think that it will be ready next month.

Hi,

Your engine is not supported by Multiecuscan yet.
The only supported module for your vehicle is the ABS module.

I will add support for some airbag ECUs probably in a month. The support for SIEMENS airbag which is used in all Stilos will come first.
The support for CAN network and service reset will be ready much later... a few months.

Did you connect the cable to pin 1 of the ODB connector? You need to connect it to pin 1 for the ABS.

Hi,
Stilo 1.6 uses either IAW 5NF or IAW 5SF CF4.
Since your car is from 2002 I think it has IAW 5NF.
Unfortunately, none of these ECUs is supported in multiecuscan yet. Check for future versions.

yes,
I'm planning to add petrol ECUs.
I already have support for some IAW ECUs.
I also have support for IAW49F which might be the ECU that is used in your car. It is used in some 1.2 Palios.

Hi,
Bisch 7.3 is not supported yet.
Do not try to connect to your car with different selection.

The oldest laptop that I have for testing is with 1GHz PIII CPU. The program works almost fine on it - It shows the latency message but does not disconnect when reading parameters. Anyway, I know why the program is using so much CPU resources. I just did not care about it because on my working lapto...