Multiecuscan

You must give us more information...

That's right. Injector coding works only with KKL or KL interface.
ELM can not do the job...

Sorry I would helped you but I am not always online...

CAn someone explain how to program remotes for alfa 156 MY2 with multiecuscan? i could not find any info about it... asked Yani too but did not received any answer. Also, i found that requests for alfa 156 key programming or remote programming are from 2010 going on... just asking what's the matter...

Hello,

To reset any airbag unit after crash you need special programmer and special software to do that.
Normal diagnostic software can not do that...

Or buy new airbag unit or send your airbag unit which have crash data to someone who can repair it...

hat sich erledigt...

For reading CODE you need special equipment... Special software and special programmer... These tools are expensive just for one CODE card... To get CODE card you have 2 options: - get it from official Fiat dealer. As us911 already wrote in Germany costs around 20-25 EURO. In west Balkan lands (ex Y...

It should do the Grande from 2009.

The example that I wrote about tyres... I did not expressed myself good...
I thought on the balance maschine - not on the laptop with MES and calibration.
Every tyre should be balanced...
So i recommend calibration for steering angle sensor...

So you need to disconnect and connect orange-yellow connector in the trunk. Open the trunk. You have textil part in trunk. On the right side, remove the textil part. Under textil part you have to find the yellow wire with orange connector. Disconnect it and connect it back again. Delete errors and n...

MES should have possibility to calibrate steering angle sensor. To have 100% answer I need basic infos from your car. I advise calibration but if you do not do it than you will after some period probably need to change that new sensor. And sensors are not cheap. Just one example. When you put new ty...

Are the numbers on old airbag ECU and new one the same or not?