Multiecuscan

Hi!
Its because your LIVE aplication has end of support.
Disable LIVE Apps in proxi and then do restore apps in radio...
You have to interrupt the process and then LIVE icon will missing in radio...
And reboots ends

I am really very surprised on you guys... You tried to do retrofits without any experiences... It is really not about asking on forum... What did you do with mood selector? Was connector prepared or did you add wirings? Which scheme did you use? Do you know correct bytes settings? Which type of car ...

HI! Upload this proxi setting 33 36 32 36 33 31 34 32 39 30 33 4F 55 54 50 55 54 44 4A 49 54 20 15 06 11 4B 10 00 04 11 00 00 00 09 00 00 04 11 00 00 00 85 C0 73 07 7B 00 00 30 A0 00 00 56 00 0F 00 00 06 0B 02 46 C0 8A 50 08 09 10 05 0C 09 00 80 00 00 00 00 00 00 54 02 44 01 00 11 00 00 00 20 00 00 ...

I had the same issue in airbag node and when i looked to FESlog after proxialignment, node asks for change byte 69 i f remember right. After byte value change passenger seatbelt reminder still runs alarm also with empty passenger seat... Of cousre after seatbelt lock it was OK... I solve it with unp...

So, problem is in uconnect setting in proxi...
Did you set radio correctly?
Did you extend proxi lenght?

Hi on some 500s is the fault in passenger seat detection or passenger seatbelt reminder...
Unplug the yellow connector below the passenger seat
and run proxialignment...

Hi I discover an error in proxialignment procedure on Tonale (maybe also on more models), where MES cant recognize few modules installed in car... I think that without it is not possible to do proxialignment procedure correctly. Because unknown moudles arent coded in proxi tab so they will be remove...

Hi!
Wiring is not same!
You have to add 2 wires for both lamps to activate DRL and for correct function of turning lights...
Then you have to change proxi settings...
Good luck!

Check FESlog file after alignment procedure...
CArPlay doesnt work on U5 radio.. Only on some U7....

Value 10 is GPS module