Multiecuscan

Hi. Did you manage to do a proxy alignment without your blue and me? Mine is faulty so it’s made the mileage flash. Keep trying to do an alignment but it fails when it try’s to do the convergence telematic node. Can I change the code so it thinks it’s not there? Yes. Follow the video in the older p...

I wish it were, things like that are the holy grail, and who knows that things usually keeps it secret, donating only few drops once in a while...

Sure, better that way

Yes. Be sure to backup your original proxy so in case of problems you can roll it back

You can PM me after 11 July, or for sure I'll forget it

You have to manually edit the proxy value. I don't remember where to do it, I'm on vacation right now and I don't have my laptop with me

I have been told to change manually byte 38 from value 42 to 02.

It worked for me

you can try to disconnect IBS sensor - it will say S&S not available and will be disabled all the time. just check if battery is charged properly with it disconnected. It works that way, but now I have the notification of the S&S not available on the display and it's really annoying. Is there anoth...

nelly19780 wrote: ↑

02 Jun 2021, 10:42

Hello,

Follow this tutorial. I used this to remove the Blue&Me module on a Punto and worked perfectly.

https://www.youtube.com/watch?v=RD__7upfeaw

Really thanks, I was missing the part while the module should be removed with no battery connected! Thanks!!!

shpuncik wrote: ↑

31 May 2021, 09:26

check in CAN Setup screen if B&M module is shown as removed. if yes, perform proxi - should remove it and odo will stop flashing.

I removed it, and it showed as removed, but the proxi align failed.

Apparently, before attempting alignment the module must be removed with the battery disconnected!