Search found 7 matches

by fxiat500
23 Nov 2017, 06:04
Forum: Usage Q&A
Topic: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Replies: 2535
Views: 3925641

Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)

Finaly i bought an elm 327with pic 25k80 (lot of them advertise when you know you have to find it). Work fully test, error, scan and proxi alignment. It is with 64 bit windows on 2009 500c. But I doubt multiecuscan have the convertible module option. Or this module have no proxyalignement and no way...
by fxiat500
19 Nov 2017, 11:08
Forum: Feature Requests
Topic: Abarth 500C roof
Replies: 1
Views: 2770

Re: Abarth 500C roof

Not in simple 1.4 16v too. I read it's not can bus module. Not sure what Lin is but it is the connection type. Maybe it explain there is no proxy alignment and operation neither.
I need to rule that out cause my boot is not opening even after my softop is back with a new roof ecu.
by fxiat500
19 Nov 2017, 10:39
Forum: General
Topic: 500 CONVERTIBLE supported ? New Roof Control Unit no proxyalignement ?
Replies: 0
Views: 1037

500 CONVERTIBLE supported ? New Roof Control Unit no proxyalignement ?

Bonjourno, My softop is working again with a new roof ecu (new but old stock to go along with my 2009 500c, all the softop motorisation change in 2011= 1500€ if you roof ecu brake up and you don't find an old stock). My boot/trunk/tailgate is now the problem: - It stop working from time to time when...
by fxiat500
17 Oct 2017, 10:52
Forum: Usage Q&A
Topic: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Replies: 2535
Views: 3925641

Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)

Windows 64bit is allowed for the ELM327 ? I saw at least one ELM's ad with "'windows 32 bit only"'.
by fxiat500
14 Oct 2017, 07:57
Forum: Usage Q&A
Topic: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Replies: 2535
Views: 3925641

Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)

Not good COMMAND: ATZ RESPONSE: COMMAND: ATI RESPONSE: COMMAND: ATE0 RESPONSE: COMMAND: ATL0 RESPONSE: COMMAND: ATH0 RESPONSE: COMMAND: ATSPC RESPONSE: COMMAND: ATS0 RESPONSE: COMMAND: ATCAF0 RESPONSE: COMMAND: ATCFC0 RESPONSE: COMMAND: ATCRA 7B0 RESPONSE: COMMAND: ATSH 7B0 RESPONSE: COMMAND: ATAT1 ...
by fxiat500
13 Oct 2017, 10:51
Forum: Usage Q&A
Topic: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Replies: 2535
Views: 3925641

Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)

Tested both side of the 121 ohm resistor close to LM chip (between two pins in the middle on one side of the chip), pin 6 and pin 14 for the plug are connected there. Still read 10Ohm on my cheap multimeter, there come my worry from so OK. The hard pin were not that hard, I cut two of them easily. M...
by fxiat500
12 Oct 2017, 09:04
Forum: Usage Q&A
Topic: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)
Replies: 2535
Views: 3925641

Re: FAULTY ELM 327 INTERFACES DE-MYSTIFIED (READ HERE)

Hi, I have connected an unmodified wifi ELM to my fiat 500 convertible. From the licenced software, I can access abs for exemple. It's connected. Now I need to access the convertible ecu to reset it and face 2 problems: 1* it is not wired inside but only hard pins an printed board. Can I connect 1 a...