Multiecuscan

Looking inside my switched vag kkl lead, I note pins 11 and 12 (not used?) have a solder bridge- is this a problem? Also, it can be n on the other pic, there is a very thin wire between pin 9 and the central row of contacts , is this normal, or could it be a problem? I assume the cetral row of pins ...

Yani,, I deactivated it on one laptop, but ca''t reach the licence server. I was ghoing to put it on another laptop, but it keeps switching off. I need to re activate it on the first one, but it does not accept the licence key, even with the hardware key still being the same. Will uninsall and repla...

Hi Yani,, yes I did check latency, sometimes it passes the test, sometimes not. Even when it passes the test I can not connect to the abs/asr 5.3 ecu. i have 2 kkl leads, one has p7 on plug soldered to red lead (see earlier post in this thread) also a switched 4 way kkl lead. I can not connect excep...

Borrowed a mifi device, only hope there i a signal in the barn which is steel framed and well insulated. Otherwise, I will do as you advise, I am checking now if it will stay alive when put to standby, whih is the only option on the computer I am using. Will post back when I have tred it. Cheers for...

Hi s130,, but wont that need an internet connection- I am down on a farm with no service. I see I can set the folders for other logs, but IIRC I can;t save an error log, just get the red send button (seen that a few times I can tell you!) I tried my modded kkl lead with wire from pin 7 soldered to p...

Well, just been down to try it all again,, thrown everything at it, can not connect to abs module. only sometimes, not all, to the engine, and thats unreliable. All connections are good in the vehicle looms etc. I have had it with this. I have a mountain of kit and for nothing. looks like it will ha...

Hi s130,, so, if I put one lead from my continuity tester on the pcb side of p1, then check selected labeled positions of 4 way switch to the male pins in the leads plug, I should get continuity on the pins as indicated on the switch, they should tally when set at the various positions. The abs come...

Hi s130...its all in the title....viz- 2005 duc 2.8 JTD Its actually a Burstner motorhome but the chassis is as above). I have changed the battery and after doing so, it left abs and h/brake lights on, so info suggests EBd ailure, but it never showed up before I did the battery (old one was properly...

Having broke the habit of a lifetime, I have coughed up good money for software to do a specific job. That being Multiecuscan v 3.5. I tried several of the free versions of this, on 4 different laptops; ALL gave varying degrees of connection problems. So I decided to buy and install the latest versi...