Multiecuscan

I am using MES with an OBD scanner ELM27 but not all the task are excuted. Example for a GPunto 1.3 mjet I can reset the sevice and the oil change for DPF, But on the other end i can NOT write the lsat service datem the number of sevices remaining, and I do not see the last service. The service coun...

HI I have MES installed on two different notebooks. An old one with XP. MES 3.6 and 3.7 is able to connect to the car with elm 327 clone and proper adpater cable BUT does not complete service reset while connects to other ECUs. The only functin that is accomplished is the DPF timer reset after oil c...

HI I have MES installed on two different notebooks. An old one with XP. MES 3.6 and 3.7 is able to connect to the car with elm 327 clone and proper adpater cable BUT does not complete service reset while connects to other ECUs. The only functin that is accomplished is the DPF timer reset after oil c...

Finally I found the proper adapter to access all modules and I was able to reset service and oil filter warning linght. I only have the problem the MULTISCAN does not show the date and reading for service even if the reset works and light disappears. I had problme resetting the warning light with ME...

x lucarossi 1963 alcune interfacce NON sono compatibili nemmeno se togli la resistenza tra i piedini di uscita. Ti consiglio di acquistare un altra interfaccia perchè non è detto che saldando un nuovo chip la circuiteria sia compatibile. Not all the interfaces are comaptible even when you remove the...

Finally I got another cheap china elm 327 and after removing the 120 ohm resistor between pins 14 and 9 I was able to connect to the CAN network but I still have something to solve with FES. I connected to the car and I was able to DISABLE the safety belt reminder. I wonder if disabling the seatbelt...

May seem like a childish question but to redirect each pin you disconnected it (interrupted sign with another switch) of the original pin? I am not sure about what you say. The dipswitch is working properly as I am using the interface on another car - an old punto without CAN - and it is working. M...

No way to have this fuckin... piece of sh.. connected to the CAN dipswitches are fine. cable 14 from board to dipswitch (in) 1 and 2. pin 1 to 9; pin 2 to 14 cable 6 from board to dipswitch 5 and 6. pin 5 to 6; pin 6 to 1 so ADAP 3 is switch 1 and 6 ON to have 14->9 and 6->1 (pin 7/12 on the car is ...

Hello Vince59 Which vehicle you would like to read Because the resistor must be removed only for CAN bus protocols You can add the marked Resistor from you but still remove Furthermore, I can not find any question ?? Greeting Eddy Hallo Eddy, as said car is a FIAT GP 1.3MJT 16V 2011. This is the OB...

I just bought a new elm327 black plastic box with orange/blue color writing. The board inside is the one you see in the pic. I used a dipswitch to have the possibility to switch from basic to OBD3 ADAPTER but the device does not connect to CAN for reset interval service while I can check the engine....