Multiecuscan

Hey thank you so much for all the answers but unfortunately it turned out to aa chip interface in v1.0. Therefore, could not be one with no solution.
Good day to everyone Thanks

Hello Stilo Of course, your problem is the CAN bus that everything you've removed and soldered it only relates to the CAN protocol. Your engine control is read with ISO14230 Presumably you've destroyed your interface with your renovation Once more: Only the resistance R04 is removed! Greetings Eddy...

Képkivágás.PNG Képkivágás.PNG Hello Stilo Have you installed the FTDI drivers? FTDI Treiber.jpg If your interface detected without error? Systemsteuerung.jpg Have you asked the Latency Time in 1? Latency Time.jpg Otherwise must be some other error Greetings Eddy Hi thank you very much for your help...

Hello Stilo Again from the beginning! I have said to you but that you have to remove the resistor R04! Only the R04 no other And I have not written anything of the additional resistors and capacitors! That are not needed! This FTDI driver is required if your interface is not recognized! If your int...

Hello Stilo Again from the beginning! I have said to you but that you have to remove the resistor R04! Only the R04 no other And I have not written anything of the additional resistors and capacitors! That are not needed! This FTDI driver is required if your interface is not recognized! If your int...

Hi I did everything you have said. Removed two resistance R04 and 2 capacitors soldered and still do not know what a proxy alignment procedure could be the problem? Help me please

... Thank you very much KRG but unfortunately I can not be connected from the image. Can you help me because they are not in the same box. Mine v1.4 They can be welded to the connector between ground and pins 6 and 14. http://i60.servimg.com/u/f60/15/90/50/17/obd11.jpg Thank you very much. Trying t...

Krg wrote:I think if you remove R04, you must add the sets R32/R33 C8/C9

Thank you very much KRG but unfortunately I can not be connected from the image. Can you help me because they are not in the same box. Mine v1.4

Hi I have the red version is
R04 removed
removed r14
CANbus network can not see does not work.
What is the solution can anyone answer?

@ stilo1.6 In your interface, it is the same resistor (R04) directly to the plug pins (121) marked Remove these and you're this interface CAN bus compatible This you have now indeed been recognized :-) @ all This distance helps only for connections in the CAN bus protocol to other protocols, this i...